回到网站

Capsules and perform filling operations

It is mainly used to pack capsules and perform filling operations on them. So when you use the , you need to understand its operating specifications, so as to ensure the safety when using it. If you don’t know enough about it, it’s okay. In the article, the editor gave you a detailed introduction to the operating specifications of form fill and seal machine and its market status. Let’s take a look!

Operation specification of capsule filling machine:

1. Press the green button in the "power switch" to turn on the power.

2. Slowly adjust the "vibration intensity adjustment knob", and then turn it clockwise. At this time, the finishing tray connected to the "vibration bracket" starts to vibrate. Touch the finishing tray with your hand and adjust the vibration intensity according to your feeling.

3. Put the powder-filled capsule shells into the "powder-filled capsule shell sorting tray", about 300 capsules each time. Put the capsule cover into the "capsule cover sorting board", about 300 capsules each time. The finishing plate is made of plexiglass plate with many circular holes, the upper funnel is larger in size, and the lower funnel is smaller in size. At this time, the capsule shell of the working platform plate moves stably and slowly, so that it can enter the holes of the platform plate one by one.

4. In about 30 seconds, the capsule shell and capsule cover filled with powder will fall into the circular hole with the opening facing upward. If the single opening is facing down, you can use the capsule cover to gently press the sleeve down, and then pull the sleeve out.

5. The entire horizontal horizontal handheld powder-filled capsule shell connecting plate.

Push slightly into the lower part of the tray, the capsule shell with powder in the tray will fall into the round hole of the adapter plate, and then take out the adapter plate. Similarly, take out the capsule cover through the capsule cover connecting plate.

6. A powder square plate with a bottom area of 500×500 mm and four sides about 10 mm high can be prepared in advance, filled with powder, and the connecting plate of the capsule shell containing the powder can be placed inside. Horizontal powder square plate. Then cover the randomly matched plexiglass frame on the powder-filled capsule connecting plate, and fill the powder with scraping powder on the edge of the frame, and then scrape off the excess powder.